CV-D3D Yellow Resin
Yellow Resin
Camvision Yellow / Orange are universal casting resins which can be used for all designs of jewellery, from fine filigree wires to solid men’s rings and plain surfaces.
They are both similar formulations however, CV-D3D casts a little better but CV-D3D prints a little sharper and is more suited for diamond jewellery.
This universal jewelry resin is immensely popular because of its versatility in terms of usage. Not only does it offer the finest casting quality, these resins are easy to use as well.
Features:
- Universal resins for all types of jewellery
- Top casting quality
- Easy burnout
- Can use normal investment powder
- Shrinkage less than 1%
Properties:
- Tensile strength: 23 Mpa
- Flexural strength: 47 Mpa
- D shor hardness: 63
- Can use normal investment powder
- Viscocity: 700 to 800 Mpas @ 24°C
Post Processing Instructions:
- Dip in Isopropyl alcohol for 1 to 2 minutes until it's mostly cleaned
- Spray the prints with Isopropyl alcohol to remove any stuck resin or stickiness
- Put prints in a glass beaker 80% full of distilled water & put the beaker in any UV curing oven for 5 to 15 minutes
- Dry the prints either (A) with a hair dryer manually or (B) in a heating oven at 75°C for 1 hour or (C) in a vacuum drying oven
Recommended Burnout Cycle:
Step 1:
- Room Temp to 100°C
- Ramp @ 2°C/minute = 30 mins
- Hold Time: 3 hours
- Total Time: 3 hours 30 mins
Step 2:
- 100°C to 730°C
- Ramp @ 5°C/minute = 2 hours 6 mins
- Hold Time: 4 hours 30 mins
- Total Time: 6 hours 36 mins
Step 3:
- 730°C to Cast Temp
- Aprox 30 mins
- Hold Time: 1 hour 30 mins
- Cast
- Total Time: 2 hours 30 mins